How Much Does It Cost To Repair Or Replace A Garage Door Spring?

Typical Range:

$150 - $350

Find out how much your project will cost.

Cost data is based on research by HomeAdvisor.

Updated April 16, 2024

Written by HomeAdvisor.

Highlights

  • Replacing garage door springs is dangerous and can cause serious injuries if not done correctly, making professional help essential.

  • The average cost to replace garage door springs ranges from $150 to $350.

  • Factors impacting garage door spring replacement cost include the number of doors, garage size, types of springs, and labor costs.

  • Garage door springs can be extension coil or torsion coil types.

  • Signs a garage door spring needs replacement include a slow-rising door, inability to open, getting stuck, or difficulty in manual operation.

  • Replacing garage door springs enhances their life span, improves door functionality, and prevents potential malfunctions.


Highlights were summarized from this existing cost guide text using automation technology and were thoroughly reviewed for accuracy by HomeAdvisor Editor Ryan Noonan.


Garage door spring repair costs an average of $250 for both materials and labor with a typical range between $150 and $350, including replacing two springs. For multi-door garages or installs needing other components replaced, you might pay up to $500.

Repair almost always means replacement, but you might only need to balance the door and lubricate the springs, which only costs $50 to $100. Materials alone (springs, brackets, and hardware) run $30 to $200 for a set of two springs with labor running $75 to $150.

Garage Door Spring Replacement Cost

Replacing garage door springs costs $150 to $350 on average. The springs alone typically run $30 to $75 each, but you may find them as low as $15 and up to $100 each. Commercial grade springs can run $300 or more. Keep in mind that most doors have two springs and you'll need to replace both at the same time. 

When repairing your garage door springs, consider these facts:

  • Garage door springs last 10,000 to 20,000 cycles. Over time, the garage door springs will weaken and eventually break.

  • Springs the part of the garage door that’s most likely to break. When your garage door malfunctions, the springs are the part you'll most often need to have repaired or replaced.

  • They come in two different types. You can choose from extension coil or torsion coil springs.

Compare Garage Door Spring Replacement Estimates
Compare Quotes

Cost To DIY Replace Garage Door Spring 

Replacing garage door springs is a dangerous job that can be life-threatening if not completed properly. The springs are under a lot of tension, and if you mishandle the repair, you could severely injure yourself. Instead, you can opt to hire a garage door professional to handle the job.

However, if you have the experience and tools necessary to complete the replacement, you can expect to pay for only the springs, which range $60 to $150 for a set.

Garage Door Spring Replacement Cost Factors

Garage door spring replacement costs vary according to several factors. Consider the following when purchasing replacement springs.

Number of Doors

Spring replacement for a single garage door with two springs costs $150 to $350. If you have a double door, it’ll cost an extra $15 to $30 more for higher-grade springs. Additionally, the cost to replace springs on two single garage doors with two springs each is $300 to $700, though you may get a discount on labor costs depending on the company.

Garage Size

If you have an extra-large garage door, it might require commercial-grade springs. These types of springs cost $100 to $500 per spring and $150 to $300 for labor.

Spring Types

Replacing torsion springs costs $75 to $150 per spring, including parts and labor. If you have extension springs, parts and labor cost $50 to $100 per spring.

Switching Spring Types

Converting from extension to torsion springs costs $400 to $800. This change can be a good investment if you’re concerned about the lack of safety cables on extension springs or are looking for springs that can last longer.

Cable Replacements

Cable replacement costs $75 to $200, although the provider may offer a discount if you also replace the springs at the same time.

Labor

Labor costs range from $75 to $150 for a typical home garage door spring repair which takes 1 to 2 hours. Additionally, labor for commercial-grade spring replacement runs $150 to $300.

Emergency Services 

If you live in a highly populated area, there is likely a local company that offers 24-hour emergency garage door repair services. You can expect to pay an extra fee for the convenience of a late-night or holiday repair.

Garage Door Spring Replacement Cost by Type

You need to know which type of spring your garage has before you can schedule replacement services. Torsion springs typically cost more to replace, but they last longer than extension springs. Costs can also vary based on the type of garage doors, such as roll up or a double garage.

Torsion Spring and Bar Replacement Cost

Torsion spring replacement costs anywhere from $75 to $150 per spring, including materials and labor. The springs alone run $30 to $100 each. You'll almost always have two springs per door, and you should replace both at the same time.

Torsion springs are located above the garage door, and they have a life expectancy of 10,000 to 20,000 cycles or about 8 to 15 years, depending on use.

Extension Spring Replacement Cost

Extension springs cost $50 to $100 per spring to replace, including labor and materials. The springs alone run $15 to $45

Extension springs are easier to install and cost less than torsion springs. However, they won't last quite as long, with projected lifespans in the 8,000 to 15,000 cycle range, or 7 to 12 years. Most come with a 3 to 5 year warranty.

Double Garage Door Spring Replacement Cost

Double-door springs often cost $15 to $30 more per spring than single-door springs because you'll likely need a larger spring to carry the extra weight. Labor costs remain the same.

Roll-Up Garage Door Springs 

The cost of spring replacement services is determined by the type and number of springs being replaced, not the type of garage door. However, the size, material, and space in the garage might make it more difficult for your pro to access areas needed for repairs, which may increase the bill.

Garage Door Spring Prices

Extension springs cost $15 to $45 per spring, while torsion springs cost $75 to $150 per spring. The most expensive types are commercial-grade springs, and they range from $100 to $500 per spring.

Broken Garage Door Spring Repair Cost

Replacing broken garage door springs costs $100 to $300 on average. When referring to garage door spring "repairs," you're always talking about replacement. You can't repair a broken spring, but you can hire a garage door pro to provide a tune-up to keep your springs in working condition. Keeping your doors maintained is much more cost effective than the cost of new garage doors.

Garage Door Spring Tune-Up Cost

You'll pay anywhere from $50 to $150 for a garage door tune-up. You should also have your garage door springs tuned one or two times a year, so they continue to work efficiently. 

A tune-up usually includes:

  • Lubricating the springs

  • Adjusting the tension on a spring if the door seems out of balance

  • Tightening any loose screws or nuts

  • Checking the cable feed, drums and rollers

FAQs

How long does a garage door spring last?

Extension springs last 8,000 to 15,000 cycles or 7 to 12 years. On the other hand, torsion springs last longer at an average of 10,000 to 20,000 cycles or 8 to 15 years. Additionally, the longevity of your springs depends on your usage and maintenance schedule.

How long does it take to replace garage door springs?

An experienced garage door repair person can typically replace two springs in 30 minutes to an hour. You can expect it to take longer if you switch spring types or have a multi-car garage.

How do I know if a garage door spring needs to be repaired or replaced?

If a garage door spring breaks, the other spring then takes the entire load. Look for these signs:

  • The garage door rises slowly.

  • The door won’t open at all.

  • It gets stuck in the tracks.

  • It's difficult to open the garage door manually.

In some cases with torsion springs, you won't even notice one went out until the second one does. Contact alocal garage door spring repair professional if you notice any of these symptoms. 

Why do garage doors break?

The three most common reasons for garage doors breaking are wear and tear, rust, and not maintaining them properly. Rusted spring parts can lead to the coils degrading faster than they should. In addition, not following a maintenance schedule or getting regular tune-ups can lead to quicker wear and tear of your doors.

How can I make garage door springs last longer? 

The best way to make your garage door springs last longer is by having them maintained by a garage door specialist. This step will catch and fix any issues promptly, and the specialist will also spray the spring with silicone-based lubricant to keep any rust at bay. 

During the maintenance service, the tech will also make sure the door is properly balanced to ensure that the springs always have the right amount of tension.

Still Have Questions About Garage Door Springs?
Ask a Pro